NUFLO Liquid Turbine Meters

NUFLO Liquid Turbine Meters
 
Overview :
Cameron' s NUFLO™ developed its first flowmeter for oilfield applications in 1957.
The meter incorporated a tungsten-carbide shaft and bearing to withstand the rugged
conditions of the oilfield environment. Over the years, this flow meter has built an
unsurpassed reputation for withstanding severe punishment while maintaining
operational and measurement integrity. NUFLO turbine flow meters indicate flow rate
and measure total throughput of a liquid line. As liquid flows through the meter and
over the rotor, the rotor turns at a speed that is directly proportional to the flow rate.
A magnetic pickup senses the rotor blades as they pass and generates an electrical
(sine wave) signal. These electrical pulses are then transmitted to the flow
measurement readout equipment.
 

Specifications :
End connections Cameron offers turbine flow meters in a variety of end connections
and accuracy levels. Typical applications are: Threaded Grooved Flanged EZ-IN®
WECO® 1502 Flanged End Connection Turbine flow meters with flanged end
connections are available in both raised-face ( RF) models and ring-type joint ( RTJ)
models. Flanged materials can be carbon steel or stainless steel. All flanged NUFLO
meters are equipped with slip-on flanges, which are then welded to the outside of the
meter rather than being welded to the end of the meter body. Thus, the flange never
comes into contact with the fluid being measured. The flanges are designed to mate
with ANSI B16.5 flanges. Grooved End Connection Flowmeters with grooved end
connections are available in 7/ 8" through 8" sizes. EZ-IN End Connection Series BF
turbine flow meters with EZ-IN connections provide a cost-effective alternative to
typical flanged-meter applications. Series BF meters with EZ-IN connections offer the
accuracy, rugged construction, and maintenance-free operation of conventional NUFLO flow meters plus the following advantages: Lower installation cost Less
expensive than a conventional, flanged meter Spreader nuts enable easy removal
and inspection The raised-face EZ-IN meter will mate to any flange rated ANSI 150#
to 1500# . The ring-joint ( RTJ) version will mate to ANSI 900# , 1500# or 2500# RTJ
flange ( specify flange type when ordering) CE-marked 8" x 8" EZ-IN RF requires
special centering rings WECO 1502 Union End Connection Flow meters with 1502
end connections are commonly used in high-pressure oilwell service applications.
Meter sizes 1” , 1-1/ 2” and 2” have 2” union end connections with a wing nut on one
end and thread on the other end. The 3" meters have 3" union end connections with
the option of a wing nut on one end and thread on the other, or threads on both ends.
All 1502 union end meters have two pickup adapters.